Thread (12 messages) 12 messages, 2 authors, 2021-03-04

Re: [PATCH 3/4] mm: /proc/sys/vm/stat_refresh skip checking known negative stats

From: Roman Gushchin <hidden>
Date: 2021-03-02 07:46:07
Also in: lkml

Mon, Mar 01, 2021 at 02:08:17PM -0800, Hugh Dickins wrote:
On Sun, 28 Feb 2021, Roman Gushchin wrote:
quoted
On Thu, Feb 25, 2021 at 03:14:03PM -0800, Hugh Dickins wrote:
quoted
vmstat_refresh() can occasionally catch nr_zone_write_pending and
nr_writeback when they are transiently negative.  The reason is partly
that the interrupt which decrements them in test_clear_page_writeback()
can come in before __test_set_page_writeback() got to increment them;
but transient negatives are still seen even when that is prevented, and
we have not yet resolved why (Roman believes that it is an unavoidable
consequence of the refresh scheduled on each cpu).  But those stats are
not buggy, they have never been seen to drift away from 0 permanently:
so just avoid the annoyance of showing a warning on them.

Similarly avoid showing a warning on nr_free_cma: CMA users have seen
that one reported negative from /proc/sys/vm/stat_refresh too, but it
does drift away permanently: I believe that's because its incrementation
and decrementation are decided by page migratetype, but the migratetype
of a pageblock is not guaranteed to be constant.

Use switch statements so we can most easily add or remove cases later.
I'm OK with the code, but I can't fully agree with the commit log. I don't think
there is any mystery around negative values. Let me copy-paste the explanation
from my original patch:

    These warnings* are generated by the vmstat_refresh() function, which
    assumes that atomic zone and numa counters can't go below zero.  However,
    on a SMP machine it's not quite right: due to per-cpu caching it can in
    theory be as low as -(zone threshold) * NR_CPUs.
    
    For instance, let's say all cma pages are in use and NR_FREE_CMA_PAGES
    reached 0.  Then we've reclaimed a small number of cma pages on each CPU
    except CPU0, so that most percpu NR_FREE_CMA_PAGES counters are slightly
    positive (the atomic counter is still 0).  Then somebody on CPU0 consumes
    all these pages.  The number of pages can easily exceed the threshold and
    a negative value will be committed to the atomic counter.

    * warnings about negative NR_FREE_CMA_PAGES
Hi Roman, thanks for your Acks on the others - and indeed this
is the one on which disagreement was more to be expected.

I certainly wanted (and included below) a Link to your original patch;
and even wondered whether to paste your description into mine.
But I read it again and still have issues with it.

Mainly, it does not convey at all, that touching stat_refresh adds the
per-cpu counts into the global atomics, resetting per-cpu counts to 0.
Which does not invalidate your explanation: races might still manage
to underflow; but it does take the "easily" out of "can easily exceed".
Hi Hugh!

It could be that "easily" simple comes from the scale (number of machines).
Since I don't use CMA on any machine, I cannot be sure, but it looked
like a bad example to rely upon, because of its migratetype-based
accounting.  If you use /proc/sys/vm/stat_refresh frequently enough,
without suppressing the warning, I guess that uncertainty could be
resolved by checking whether nr_free_cma is seen with negative value
in consecutive refreshes - which would tend to support my migratetype
theory - or only singly - which would support your raciness theory.
quoted
Actually, the same is almost true for ANY other counter. What differs CMA, dirty
and write pending counters is that they can reach 0 value under normal conditions.
Other counters are usually not reaching values small enough to see negative values
on a reasonable sized machine.
Looking through /proc/vmstat now, yes, I can see that there are fewer
counters which hover near 0 than I had imagined: more have a positive
bias, or are monotonically increasing.  And I'd be lying if I said I'd
never seen any others than nr_writeback or nr_zone_write_pending caught
negative.  But what are you asking for?  Should the patch be changed, to
retry the refresh_vm_stats() before warning, if it sees any negative?
Depends on how terrible one line in dmesg is considered!
quoted
Does it makes sense?
I'm not sure: you were not asking for the patch to be changed, but
its commit log: and I better not say "Roman believes that it is an
unavoidable consequence of the refresh scheduled on each cpu" if
that's untrue (or unclear: now it reads to me as if we're accusing
the refresh of messing things up, whereas it's the non-atomic nature
of the refresh which leaves it vulnerable to races).
I think we both agree that for some counters going slightly into negative
is possible and isn't an indication of an error, if only they don't become
too negative. For other counters it's unlikely: so you see a value in
raising a warning when they do. I don't think there is any disagreement here.

So the only question is how we encode the list of counters which we're
comparing to 0 (we can list them or list all others, as in your version),
and what we do with the rest (we can ignore them completely or compare
with the maximum drift value, as in my original patch). I actually don't
care that much how exactly it's implemented, if only we're not generating
too many false warnings.

How about putting something like this into the commit log (I'm sure you
can put it better than me. Please, do!):

"For performance reasons vmstat counters are incremented and decremented
using percpu batches. vmstat_refresh() flushes per-cpu batches on all CPUs
to get as accurate values, as possible. However, because this process
is not atomic, the resulting value is not exactly precise. As a consequence,
for some counters, which real value tend to oscillate around 0, it's possible
to obtain a slightly negative value. If the value is relatively small and
the state is transient, it's not an indication on an error."

Thanks!
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help