On Sat, Dec 24, 2016 at 7:00 PM, Nicholas Piggin [off-list ref] wrote:

Add a new page flag, PageWaiters, to indicate the page waitqueue has
tasks waiting. This can be tested rather than testing waitqueue_active
which requires another cacheline load.

Ok, I applied this one too. I think there's room for improvement, but
I don't think it's going to help to just wait another release cycle
and hope something happens.

Example room for improvement from a profile of unlock_page():

   46.44 │      lock   andb $0xfe,(%rdi)
   34.22 │      mov    (%rdi),%rax

this has the old "do atomic op on a byte, then load the whole word"
issue that we used to have with the nasty zone lookup code too. And it
causes a horrible pipeline hickup because the load will not forward
the data from the (partial) store.

 Its' really a misfeature of our asm optimizations of the atomic bit
ops. Using "andb" is slightly smaller, but in this case in particular,
an "andq" would be a ton faster, and the mask still fits in an imm8,
so it's not even hugely larger.

But it might also be a good idea to simply use a "cmpxchg" loop here.
That also gives atomicity guarantees that we don't have with the
"clear bit and then load the value".

Regardless, I think this is worth more people looking at and testing.
And merging it is probably the best way for that to happen.

                Linus

--
To unsubscribe, send a message with 'unsubscribe linux-mm' in
the body to majordomo@kvack.org.  For more info on Linux MM,
see: http://www.linux-mm.org/ .
Don't email: <a href=mailto:"dont@kvack.org"> email@kvack.org </a>