[PATCH v2 0/6] HID: hid-lenovo-go: fix controller configuration

This series fixes several issues in the controller configuration and
calibration paths in hid-lenovo-go.

1/6 fixes the calibration attributes, where the command and sub-command
are swapped. 2/6 fixes two right-controller attributes: imu_enabled
selects the bypass feature, and reset targets the left controller.

Before 3/6, any decoded configuration reply completes the shared
completion. The driver then ignores the result of the wait, so an
unrelated reply, a firmware error, an interrupted wait, or a timeout can
still be reported as success.

3/6 tracks one pending request in the driver data and matches replies by
command ID, command, sub-command, and device. It also returns request
errors to the caller.

The firmware has no sequence number, so a late reply with the same tuple
can still match a newer request.

The remaining patches fix calibration status handling.

The calibration status table defines 0x00 as unknown, 0x01 as success,
and 0x02 as failure. A Legion Go 1 returned 0x08 after a Stop was sent
while no calibration was active. The driver stores the raw value as a
status-text index, so a later read returns -EINVAL.

4/6 preserves the defined values and maps larger status values to
failure.

5/6 rejects 'unknown' as an action. The action table contains it at index
zero, but the options attribute advertises only 'start' and 'stop'.

A previous result can also hide a new calibration attempt:

failure -> start -> failure

The status appears unchanged for the whole operation. 6/6 clears the
selected status to unknown before submitting a Start. Stop leaves the
status unchanged.

---
Changes in v2:
- Drop the FPS DPI patch; the existing request is correct.
- Drop the v1 Boolean calibration-result mapping. Preserve values 0x00
  through 0x02 and map only larger failure values.
- Move the existing pending command state into the driver data and
  initialize it in cfg_probe().
- Use scoped IRQ-save guards and validate the report size and ID together.
- Drop the v1 no-wait calibration path. Correct requests receive their
  matching SET replies within the existing 50 ms timeout.
- Reject 'unknown' and clear only the selected status on Start.

v1: https://lore.kernel.org/all/20260821214810.87826-1-mradityadash@gmail.com/ (local)


Aditya Dash (6):
  HID: hid-lenovo-go: use the correct calibration commands
  HID: hid-lenovo-go: use the right controller selectors
  HID: hid-lenovo-go: return configuration request errors
  HID: hid-lenovo-go: normalize calibration failure status
  HID: hid-lenovo-go: reject unknown calibration action
  HID: hid-lenovo-go: clear calibration status on start

 drivers/hid/hid-lenovo-go.c | 179 +++++++++++++++++++++++++++---------
 1 file changed, 136 insertions(+), 43 deletions(-)


base-commit: 1292bca0f8d835d2ad96d309595b2e97f3106d3d
-- 
2.55.0