Thread (18 messages) 18 messages, 3 authors, 2023-10-13

Re: [PATCH V2 1/2] dt-bindings: input: Introduce Himax HID-over-SPI device

From: yang tylor <hidden>
Date: 2023-09-25 01:44:36
Also in: linux-devicetree, lkml

On Fri, Sep 22, 2023 at 11:31 PM Conor Dooley [off-list ref] wrote:
On Fri, Sep 22, 2023 at 05:43:54PM +0800, yang tylor wrote:
quoted
On Fri, Sep 22, 2023 at 5:22 PM Conor Dooley [off-list ref] wrote:
quoted
On Fri, Sep 22, 2023 at 03:56:25PM +0800, yang tylor wrote:
quoted
On Tue, Sep 19, 2023 at 7:09 PM Conor Dooley [off-list ref] wrote:
quoted
On Tue, Sep 19, 2023 at 05:31:29PM +0800, yang tylor wrote:
quoted
quoted
quoted
The behavior of "himax,boot_time_fw_upgrade" seems not stable and
should be removed. "himax,fw_in_flash", I use the kernel config for
user to select.
That seems like a bad idea, we want to be able to build one kernel that
works for all hardware at the same time.
I see, so I should take that back?
I'll explain more about it.
Are there particular ICs where the firmware would always be in flash and
others where it would never be? Or is this a choice made by the board or
system designer?
Most cases it's about the system designer's decision. But some ICs may be forced
to use flash because of its architecture(multiple IC inside, need to
load firmware to
multiple IC's sram by master IC). But if there is no limitation on
this part, most system
designers will prefer flashless.
Forgive me if I am not understanding correctly, there are some ICs that
will need to load the firmware from flash and there are some where it
will be a decision made by the designer of the board. Is the flash part
of the IC or is it an external flash chip?
Both are possible, it depends on the IC type. For TDDI, the IC is long
and thin, placed on panel PCB, flash will be located at the external
flash chip. For the OLED TP, IC is usually placed at FPC and its flash
is embedded, thus the IC size is large compared to TDDI. But from the
driver's perspective either external flash or embedded flash, the IC
itself will load firmware from flash automatically when reset pin is
released. Only if firmware is loading from the host storage system,
the driver needs to operate the IC in detail.
Cheers,
Conor.

Thanks,
Tylor
Keyboard shortcuts
hback out one level
jnext message in thread
kprevious message in thread
ldrill in
Escclose help / fold thread tree
?toggle this help