On Thu, Sep 17, 2020 at 04:44:18PM +0300, Jarkko Nikula wrote:

On 9/17/20 8:22 AM, Sultan Alsawaf wrote:

quoted

From: Sultan Alsawaf <redacted>

The point of adding a byte to len in i2c_dw_recv_len() is to make sure
that tx_buf_len is nonzero, so that i2c_dw_xfer_msg() can let the i2c
controller know that the i2c transaction can end. Otherwise, the i2c
controller will think that the transaction can never end for block
reads, which results in the stop-detection bit never being set and thus
the transaction timing out.

Adding a byte to len is not a reliable way to do this though; sometimes
it lets tx_buf_len become zero, which results in the scenario described
above. Therefore, just directly ensure tx_buf_len cannot be zero to fix
the issue.

Fixes: c3ae106050b9 ("i2c: designware: Implement support for SMBus block read and write")
Signed-off-by: Sultan Alsawaf <redacted>
---
  drivers/i2c/busses/i2c-designware-master.c | 5 +++--
  1 file changed, 3 insertions(+), 2 deletions(-)

Were other patches in series dropped somewhere? I received only this.

@linux.intel.com has some issues in delivery (accepting) messages. You may
download thru lore.kernel.org entire series and reply.

-- 
With Best Regards,
Andy Shevchenko