RE: [PATCH V17 3/3] Input: new da7280 haptic driver

On Fri, July 24, 2020 5:51 AM, Randy Dunlap wrote

On 7/23/20 8:01 AM, Roy Im wrote:

quoted

diff --git a/drivers/input/misc/Kconfig b/drivers/input/misc/Kconfig
index 362e8a0..06dc5a3 100644
--- a/drivers/input/misc/Kconfig
+++ b/drivers/input/misc/Kconfig

@@ -869,4 +869,17 @@ config INPUT_STPMIC1_ONKEY
 	  To compile this driver as a module, choose M here: the
 	  module will be called stpmic1_onkey.

+config INPUT_DA7280_HAPTICS
+	tristate "Dialog Semiconductor DA7280 haptics support"
+	depends on INPUT && I2C
+	select INPUT_FF_MEMLESS
+	select REGMAP_I2C
+	help
+	  Say Y to enable support for the Dialog DA7280 haptics driver.
+	  The haptics can be controlled by I2C communication,
+	  or by PWM input, or by GPI.

	  Is that                GPIO.
?

The Haptics can be working by GPI(if see from the haptic device), but from the Host it is GPO. Do you think the GPIO is correct?

Can the haptics be controlled only by PWM or only by GPI(O)?

Just curious: why is I2C required to build the driver if a user is only controlling the device by PWM or GPI?

I2C is required to control registers and it can be triggered by I2C or PWM or GPI(controlled by host outside this driver), so PWM and GPI are optional.
With your comments, I think it's better to remove below lines(//remove) to avoid confusion and add PWM as below if you agree.
         // remove
	  The haptics can be controlled by I2C communication,
	  or by PWM input, or by GPI.
         // update, adding || PWM
         depends on (INPUT && I2C) || PWM

quoted

+
+	  To compile this driver as a module, choose M here: the
+	  module will be called da7280.
+
 endif

thanks.
--
~Randy

Kind regards,
Roy