Re: [PATCH v3] input: pxrc: new driver for PhoenixRC Flight Controller Adapter

On Wed, Jan 17, 2018 at 02:58:40PM +0100, Marcus Folkesson wrote:

Hello Dmitry,

On Tue, Jan 16, 2018 at 03:16:25PM -0800, Dmitry Torokhov wrote:

quoted

Hi Marcus,

On Sat, Jan 13, 2018 at 09:15:32PM +0100, Marcus Folkesson wrote:

quoted

This driver let you plug in your RC controller to the adapter and
use it as input device in various RC simulators.

Signed-off-by: Marcus Folkesson <marcus.folkesson@gmail.com>
---
v3:
	- Use RUDDER and MISC instead of TILT_X and TILT_Y
	- Drop kref and anchor
	- Rework URB handling
	- Add PM support

How did you test the PM support? By default the autopm is disabled on
USB devices; you need to enable it by writing to sysfs (I believe you
need to 'echo "auto" > /sys/bus/usb/<device>/power/control) and see if
it gets autosuspended when not in use and resumed after you start
interacting with it.

The test I've done is simply reading from the input device and then call
`pm-suspend`.
It works, suspend is called and reset_resume() will submit the URB
again. Without the PM code, the application did not read any events upon
resume.

We are talking about different things. You are testing system suspend,
whereas I was talking about runtime suspend (that's what
usb_autopm_get_interface() and friends does). It is disabled by default
and you need to enable it by writing into sysfs as I mentioned above.
Then, after a few seconds of not touching the device you should see the
USB interface going into low power state and the device shoudl correctly
implement remote wakeup signal to wake up the host controller/port when
user touches it. If the device does not implement this correctly, then
after suspending it will "die".

However, I found another tricky part.
If I enable autosuspend (as you suggest) it will suspend when noone is
using the device. Good.

But when someone is opening the device, input_dev->users is counted up
to 1 before resume() is called. 
Is this intended?

This code (from resume()) will therefor allways submit the URB:

if (input_dev->users && usb_submit_urb(pxrc->urb, GFP_NOIO) < 0)


Then open() is called and fails because the urb is allready submitted.

input_dev->users is only incremented in input.c:input_open_device() what
I can tell?

It is intended, but I guess we should not be using input_dev->users in
resume(), but rather have a local flag in your driver structure trhat
you update at the right time (i.e. after you submit USB in pxrc_open()).

I suppose we need the same fix in synaptics_usb.c...

I will move the submitting code to reset_resume() instead.

You need both resume() and reset_resume(), they are called in different
cases and you need to restart IO in both cases.

Thanks.

-- 
Dmitry