Hi,

On Thursday 05 February 2015 11:51 AM, Vignesh R wrote:

On Wednesday 21 January 2015 03:44 PM, Vignesh R wrote:

quoted

On Tuesday 20 January 2015 09:34 PM, Lee Jones wrote:

quoted

On Tue, 20 Jan 2015, R, Vignesh wrote:

quoted

On 1/20/2015 5:23 PM, Lee Jones wrote:

quoted

On Wed, 07 Jan 2015, Vignesh R wrote:

quoted

In one shot mode, sequencer automatically disables all enabled steps at
the end of each cycle. (both ADC steps and TSC steps) Hence these steps
need not be saved in reg_se_cache for clearing these steps at a later
stage.
Also, when ADC wakes up Sequencer should not be busy executing any of the
config steps except for the charge step. Previously charge step was 1 ADC
clock cycle and hence it was ignored.
TSC steps are always disabled at the end of each conversion cycle, hence
there is no need to explicitly disable TSC steps by writing 0 to REG_SE.

Signed-off-by: Vignesh R <redacted>
---

v5:
 - Remove unnecessary clearing of REG_SE

 drivers/mfd/ti_am335x_tscadc.c       | 13 +++++--------
 include/linux/mfd/ti_am335x_tscadc.h |  1 +
 2 files changed, 6 insertions(+), 8 deletions(-)

Looks fine.

For my own reference:
  Acked-by: Lee Jones [off-list ref]

Can this patch be applied on its own?

I prefer to wait until input patches are picked up.

I have no problem with that, but is there a technical reason why?

Nothing, in particular. This patch alone has no impact on the
performance of TSC/ADC unit. Patch 2/6 is necessary to observe the
changes caused by this series. Hence, please wait until those patches
are picked up.

Input maintainer has applied other patches. You can pick this one.

Gentle ping... Can you pull this patch into 4.0-rc? Other patches of
this series are already in mainline.

Regards
Vignesh