Re: HID joystick - Axis 11 non operational.

On Sat, 4 Jun 2011 22:45:46 +0200
Antonio Ospite [off-list ref] wrote:

On Fri, 3 Jun 2011 16:15:11 +0200
Antonio Ospite [off-list ref] wrote:

quoted

I confirm that the axis for Dpad-left (usage->code == 0x2f IINM) of the
Sixaxis looks like it is not working. I too can see the data on hidraw
device but not on the joystick or even the event device, so it may be
below the joystick layer.

OK found something: 0x2f is ABS_MT_SLOT,
http://lxr.linux.no/linux+*/include/linux/input.h#L773

And in input.c::input_handle_abs_event() this case is handled in a
special way:
http://lxr.linux.no/#linux+v2.6.39/drivers/input/input.c#L172

This little change improves things a little bit, but the pressure event is
now reported twice, once with the actual value and once with 0, you can test
with:

 $ evtest /dev/input/eventX | \
   egrep -v 'code (0|1|2|5|48|49|50|51|52|53|54|55|56|57|58|58|59)|Report Sync'

The second ABS_MT_SLOT event is fired up here:
http://lxr.linux.no/#linux+v2.6.39/drivers/input/input.c#L210

when I get code == 0x30 (ABS_MT_TOUCH_MAJOR, I am still not sure
where from), with the following hack I can make axis 11 work again but I
have no idea if I am broking MultiTouch devices, anyone?

Index: linux-2.6/drivers/input/input.c
===================================================================

--- linux-2.6.orig/drivers/input/input.c
+++ linux-2.6/drivers/input/input.c

@@ -169,7 +169,7 @@
        bool is_mt_event;
        int *pold;
 
-       if (code == ABS_MT_SLOT) {
+       if (code == ABS_MT_SLOT && dev->mtsize > 0) {
                /*
                 * "Stage" the event; we'll flush it later, when we
                 * get actual touch data.

@@ -205,7 +205,8 @@
        }
 
        /* Flush pending "slot" event */
-       if (is_mt_event && dev->slot != input_abs_get_val(dev, ABS_MT_SLOT)) {
+       if (is_mt_event && dev->slot != input_abs_get_val(dev, ABS_MT_SLOT) &&
+           dev->mtsize > 0 ) {
                input_abs_set_val(dev, ABS_MT_SLOT, dev->slot);
                input_pass_event(dev, EV_ABS, ABS_MT_SLOT, dev->slot);
        }

Simon, if that works for you too, I can send an RFC patch out, but how should
we motivate it? The Sixaxis is sending out MT events even if it is not a MT
device...

Regards,
   Antonio

-- 
Antonio Ospite
http://ao2.it

PGP public key ID: 0x4553B001

A: Because it messes up the order in which people normally read text.
   See http://en.wikipedia.org/wiki/Posting_style
Q: Why is top-posting such a bad thing?