Re: HowTo write a driver for 2 multiplexed PS/2 ports over 1 UART?

Hello Dmitry,

Dmitry Torokhov wrote:

On Sunday 19 April 2009 03:04:25 Heiko Schocher wrote:

quoted

Hello Dmitry,

Dmitry Torokhov wrote:

quoted

You need to create 2 serio ports in your driver and have it send data
into appropriate port, depending on what device it came from. If you
take a look at i8042 driver it does exactly that. We have 1 serio port
for keyboard and eithe 1 or 4 AUX serio ports. In i8042_interrupt we
check the status bit to figure to which serio port incoming byte should
be routed and act accordingly.

Ah, thanks for this hint :-)

OK, so I have to write a serial driver for the uart on my hardware,
and add this in drivers/serio, right?

Hmm.. spontaneous I think (maybe it is a bad thought), what do you
think to the following approach:

I didn;t want to write a new serio driver for my uart (mpc5200 internal
PSC Uart), because there is a working tty driver for this, and the multi-
plexing functionality is just a protocoll ... so I think of using
the drivers/serio/serport.c and add this "multiplexing" functionality
to the serport.c driver ... is this worth about to think?

this should be a more general approach then writting a special serial
driver for "my" UART ... what do you think?

Yes, this is definitely better solution. I did not realize that there
was a working driver for your UART. It would be best if your solution
extended (and was compatible with) current N_MOUSE line discipline.

OK, thanks for your info, I hope I get this project, so I can do this
job.

bye
Heiko
-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany