Re: [regression] LID switch and /dev/input/event*

Németh Márton wrote:

Zhao Yakui wrote:

quoted

On Sat, 2008-08-23 at 23:43 +0200, Németh Márton wrote:

quoted

Hi,

I am using Linux 2.6.27-rc4 on Clevo D410J laptop and the I can
query the LID switch state like this:

# cat /proc/acpi/button/lid/LID/state
state:      open
# cat /proc/acpi/button/lid/LID/state
state:      closed

If I check the event4, I get no events when the LID switch is pushed:

# evtest /dev/input/event4
Input driver version is 1.0.0
Input device ID: bus 0x19 vendor 0x0 product 0x5 version 0x0
Input device name: "Lid Switch"
Supported events:
  Event type 0 (Sync)
  Event type 5 (?)
    Event code 0 (?)
Testing ... (interrupt to exit)

It seems that the status of LID device is correct, but there is no LID
input event. Right?
Will you please enable the CONFIG_ACPI_DEBUG in kernel configuration and
boot the system with the option of "acpi.debug_layer=0x00090004
acpi.debug_level=0x01f"? 
After pressing the LID switch several times, please attach the output of
dmesg.

It will be great if you can attach the output of acpidump.

Of course you can open a new bug in bugzilla and attach the output of
dmesg, acpidump.

http://bugzilla.kernel.org/enter_bug.cgi?product=ACPI

Thanks.

What I could find out since then is that the Linux kernel 2.6.25 is
working correctly, but 2.6.26-rc3 is bad. I am about to "git bisect"
the problem and I'll create a bugreport and provide the asked information.
This will take some time, however, as I am currently busy with different
topics.

Bug report was created: http://bugzilla.kernel.org/show_bug.cgi?id=11428

quoted

quoted

The events are only reported if I suspend to RAM with "s2ram -f -p -s". I did
the following steps:

1. Execute "s2ram -f -p -s". Now the system suspends to RAM.
2. Push the LID switch and hold it down.
3. Wake the system with the POWER button.
4. After the system is up, release the LID switch to see the screen.
5. "evtest" reports the following line:

Event: time 1219526119.163805, type 5 (?), code 0 (?), value 1

6. Execute "s2ram -f -p -s" again.
7. Wake the system with the POWER button.
8. "evtest" reports the following line:

Event: time 1219526913.208803, type 5 (?), code 0 (?), value 0

	Márton Németh

--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html