[PATCH 4/6] pata_amd: fix checking of DMA state
From: Reimar Döffinger <hidden>
Date: 2021-10-12 06:28:44
Subsystem:
libata subsystem (serial and parallel ata drivers), the rest · Maintainers:
Damien Le Moal, Niklas Cassel, Linus Torvalds
Checking if DMA is enabled should be done via the ata_dma_enabled helper function, since the init state 0xff indicates disabled. Change based on code review, not tested due to lack of hardware. Signed-off-by: Reimar Döffinger <redacted> --- drivers/ata/pata_amd.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/ata/pata_amd.c b/drivers/ata/pata_amd.c
index c8acba162d02..154748cfcc79 100644
--- a/drivers/ata/pata_amd.c
+++ b/drivers/ata/pata_amd.c@@ -66,7 +66,7 @@ static void timing_setup(struct ata_port *ap, struct ata_device *adev, int offse if (peer) { /* This may be over conservative */ - if (peer->dma_mode) { + if (ata_dma_enabled(peer)) { ata_timing_compute(peer, peer->dma_mode, &apeer, T, UT); ata_timing_merge(&apeer, &at, &at, ATA_TIMING_8BIT); }
--
2.33.0