Hi Tejun,

On 21.8.2017 13:17, Michal Simek wrote:

From: Anurag Kumar Vulisha <redacted>

In SATA Speed negotiation happens with  OOB(Out of Band) signals. These OOB
signal timing values are configured through vendor specific registers in the
SATA controller. These OOB timings depends on the generator and detector clock
frequency, which varies from board to board (ex: ep108 and zc1751 has different
clock frequencies).
To avoid maintaing these OOB settings in the driver, it is better to move these
settings to the device-tree node and read from the device-tree.

This patch does the same.

Signed-off-by: Anurag Kumar Vulisha <redacted>
Signed-off-by: Michal Simek <redacted>

Can you please look at these patches?

Thanks,
Michal

-- 
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Xilinx Microblaze
Maintainer of Linux kernel - Xilinx Zynq ARM and ZynqMP ARM64 SoCs
U-Boot custodian - Xilinx Microblaze/Zynq/ZynqMP SoCs