Re: 2.6.11-rc5: sata_sil shows drive twice...

Prakash Punnoor wrote:

hi,

dmesg shows this:


-- ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
ACPI: PCI interrupt 0000:01:0b.0[A] -> GSI 18 (level, high) -> IRQ 18
ata1: SATA max UDMA/100 cmd 0xF0806080 ctl 0xF080608A bmdma 0xF0806000 irq 18
ata2: SATA max UDMA/100 cmd 0xF08060C0 ctl 0xF08060CA bmdma 0xF0806008 irq 18
ata1: dev 0 cfg 49:2f00 82:346b 83:7f01 84:4003 85:3c69 86:3c01 87:4003 88:20ff
ata1: dev 0 ATA, max UDMA7, 156368016 sectors: lba48
ata1: dev 0 configured for UDMA/100
scsi0 : sata_sil
ata2: no device found (phy stat 00000000)
scsi1 : sata_sil
  Vendor: ATA       Model: SAMSUNG SP0812C   Rev: SU10
  Type:   Direct-Access                      ANSI SCSI revision: 05
SCSI device sda: 156368016 512-byte hdwr sectors (80060 MB)
SCSI device sda: drive cache: write back
SCSI device sda: 156368016 512-byte hdwr sectors (80060 MB)
SCSI device sda: drive cache: write back
 sda: sda1 sda2 sda3 sda4 < sda5 >
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0,  type 0


but I only have one physical drive attached. I don't seem to have problems
though. Yesterday I got an oops, but I don't know whether it is connected. I
copied it here just in case.

I don't know whether rc4 or earlier showed this beahaviour. I am sure that
2.6.10 didn't show it.

The double-output is normal for the SCSI layer, and has occurred on 2.6.10 and previous.

The oops has nothing to do with SATA.

	Jeff