On Tue, Feb 04, 2014 at 05:23:09PM +0000, Mark Brown wrote:
On Tue, Feb 04, 2014 at 07:19:08AM -0500, Matt Porter wrote:
quoted
Add a DT binding for the BCM59056 PMU. The binding inherits from
the generic regulator bindings.
Is this really only a regulator - does the chip have no other functions?
It's your average multi-function device with other functions as you are
suspecting. Buried in the the MFD driver comments is me admitting that
I need to split this into two bindings. The base device, "bcm59056" and
then "bcm59056-reg". So point noted, I'll updated with the appropriate
binding for each.
quoted
+- regulators: This is the list of child nodes that specify the regulator
+ initialization data for defined regulators. Generic regulator bindings
+ are described in regulator/regulator.txt.
The regulators property should always be optional, the driver should be
able to start up and read back the hardware state without any further
configuration.
Ahh, ok. I will make it so.
Thanks,
Matt