Hi Alexander,

On Thu, 30 Aug 2012 09:49:52 +0200
Alexander Stein [off-list ref] wrote:

quoted

Whenever you call i2c_register_board_info(), every I2C bus number
referenced in the I2C device list passed as a parameter is reserved for
static I2C bus numbers, dynamic I2C bus numbers will never overlap.

So in the quoted example, if i2c-isch is able to dynamically pick I2C
bus number 0 while i2c-eg20t want it statically, it means that either
no device was declared on bus 0 with i2c_register_board_info(), or
i2c_register_board_info() was called too late in the game.

In my case i2c_register_board_info is never called due to a non-existant platform setup (see below).

I think we can have that, and we did have that for a non-product platform,
it's easy to add a platform driver which can use dmidecode info to
identify itself.

quoted

Note that there was an assumption at the time the code was written,
that there was no need or reason to reserve a static I2C bus number if
no slave device was declared on said I2C bus. I never much liked it but
it never caused problems so far. This means that either:
* you call i2c_register_board_info() to register your slave I2C devices
  and all the affected I2C bus drivers call i2c_add_numbered_adapter();
  or
* you don't call i2c_register_board_info() and all I2C bus drivers call
  i2c_add_adapter().
You can't mix, i.e. if you don't register any slave device on a bus but
the bus driver still calls i2c_add_numbered_adapter(), it may fail.

If this is a problem now on some systems, it should be easy enough to
work around by adding a specific function to reserve an I2C bus number
for static allocation, even without declaring any slave device on it.
This function would be called at the same time
i2c_register_board_info() typically is.

IMO the i2c_register_board_info only works in quite static setups. Especially with I2C-Busses attached to hotplugable PCI devices this way doesn't work reliable any more.
The device come and go dynamically so you can't assume fixed mapping.

Can you specify the hotplugable?
1. A hotplugable i2c bus controller (say i2c_eg20t) with all fixed i2c
 devices connecting to it
2. i2c bus controller is fixed, while the i2c devices will be dynamically
 connected to it.
3. Both the bus controller and devices are dynamically hotplugged

Thanks,
Feng