On 18.08.21 10:10, Piyush Mehta wrote:

This patch adds driver support for the zynqmp modepin GPIO controller.
GPIO modepin driver set and get the value and status of the PS_MODE pin,
based on device-tree pin configuration. These four mode pins are
configurable as input/output. The mode pin has a control register, which
have lower four-bits [0:3] are configurable as input/output, next four-bits
can be used for reading the data  as input[4:7], and next setting the
output pin state output[8:11].

Signed-off-by: Piyush Mehta <redacted>
Acked-by: Michal Simek <redacted>
Reviewed-by: Linus Walleij <redacted>
---

+/**
+ * modepin_gpio_dir_in - Set the direction of the specified GPIO pin as input
+ * @chip:	gpio_chip instance to be worked on
+ * @pin:	gpio pin number within the device
+ *
+ * Return: 0 always
+ */
+static int modepin_gpio_dir_in(struct gpio_chip *chip, unsigned int pin)
+{
+	return 0;
+}

You say the gpio controller can configure pins as inputs or outputs.
Yet, .direction_input is doing nothing. So it's not clear to me,
how this sequence could work:

 - set gpio output high (writes bootmode)
 - set gpio to input (no-op, pin will remain high, not high impedance)

I didn't check the previous discussions, but if this indeed works as intended,
the how should be written here into the driver. That is a more useful comment
than kernel doc for a stub function.

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |