Hi Rafael,

Subject: RE: [PATCH v5 0/3] TPS68470 PMIC drivers

Hi Rafael,

quoted

quoted

quoted

quoted

quoted

quoted

quoted

This is the patch series for TPS68470 PMIC that works as a
camera

PMIC.

quoted

quoted

quoted

quoted

quoted

quoted

The patch series provide the following 3 drivers, to help
configure the

voltage regulators, clocks and GPIOs provided by the TPS68470 PMIC,
to be able to use the camera sensors connected to this PMIC.

quoted

quoted

quoted

quoted

TPS68470 MFD driver:
This is the multi function driver that initializes the
TPS68470 PMIC and

supports the GPIO and Op Region functions.

quoted

quoted

quoted

quoted

TPS68470 GPIO driver:
This is the PMIC GPIO driver that will be used by the OS
GPIO layer,

when the BIOS / firmware triggered GPIO access is done.

quoted

quoted

quoted

quoted

TPS68470 Op Region driver:
This is the driver that will be invoked, when the BIOS /
firmware

configures the voltage / clock for the sensors / vcm devices
connected to the PMIC.

quoted

quoted

quoted

quoted

All three patches are good to me (we did few rounds of
internal review before posting v4)

Reviewed-by: Andy Shevchenko <redacted>

OK, so how should they be routed?

Good question. I don't know how last time PMIC drivers were
merged, here I think is just sane to route vi MFD with immutable
branch created.

OK

I will assume that the series will go in through MFD then.

Now that the MFD and GPIO patches of v6 of this series have been
applied

on respective trees, can you advise the next steps for the ACPI / PMIC
Opregion driver?

Well, it would have been better to route the whole series through one tree.
Now it's better to wait until the two other trees get merged and then
apply the opregion patch.

Ack.
Let me get back once the other 2 trees are merged.

Both MFD and GPIO patches of this series got merged upstream as of today.

Thanks
Raj