@@ -37,8 +37,23 @@ Optional properties:
  - st,syscfg: Should be phandle/offset pair. The phandle to the syscon node
    which includes IRQ mux selection register, and the offset of the IRQ mux
    selection register.
+ - ngpios: Number of gpios in a bank (to use if bank gpio numbers is less
+   than 16).
+ - gpio-ranges: Define a dedicated mapping between a pin-controller and
+   a gpio controller. Format is <&phandle a b c> with:
+	-(phandle): phandle of pin-controller.
+	-(a): gpio base offset in range.
+	-(b): pin base offset in range.
+	-(c): gpio count in range
+   This entry has to be used either if there are holes inside a bank:
+	GPIOB0/B1/B2/B14/B15 (see example 2)
+   or if banks are not contiguous:
+	GPIOA/B/C/E...
+   NOTE: If "gpio-ranges" is used for a gpio controller, all gpio-controller
+   have to use a "gpio-ranges" entry.
+   More details in Documentation/devicetree/bindings/gpio/gpio.txt.
 
-Example:
+Example 1:
 #include <dt-bindings/pinctrl/stm32f429-pinfunc.h>
 ...
 

@@ -60,6 +75,43 @@ Example:
 		pin-functions nodes follow...
 	};
 
+Example 2:
+#include <dt-bindings/pinctrl/stm32f429-pinfunc.h>
+...
+
+	pinctrl: pin-controller {
+		#address-cells = <1>;
+		#size-cells = <1>;
+		compatible = "st,stm32f429-pinctrl";
+		ranges = <0 0x40020000 0x3000>;
+		pins-are-numbered;
+
+		gpioa: gpio@40020000 {
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <0x0 0x400>;
+			resets = <&reset_ahb1 0>;
+			st,bank-name = "GPIOA";
+			gpio-ranges = <&pinctrl 0 0 16>;
+		};
+
+		gpiob: gpio@40020400 {
+			gpio-controller;
+			#gpio-cells = <2>;
+			reg = <0x0 0x400>;
+			resets = <&reset_ahb1 0>;
+			st,bank-name = "GPIOB";
+			ngpios = 4;
+			gpio-ranges = <&pinctrl 0 16 3>,
+				      <&pinctrl 14 30 2>;
+		};
+
+
+		...
+		pin-functions nodes follow...
+	};
+
+
 Contents of function subnode node:
 ----------------------------------
 Subnode format