[PATCH 4/4] gpio: ptxpmb-ext-cpld: Document bindings of PTXPMB extended CPLD
From: Pantelis Antoniou <hidden>
Date: 2016-10-07 15:23:36
Also in:
linux-devicetree, linux-i2c, linux-watchdog, lkml, netdev
Subsystem:
gpio subsystem, open firmware and flattened device tree bindings, the rest · Maintainers:
Linus Walleij, Bartosz Golaszewski, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
From: Georgi Vlaev <redacted> Add device tree bindings document for the GPIO driver of Juniper's PTXPMB extended CPLD. Signed-off-by: Georgi Vlaev <redacted> [Ported from Juniper kernel] Signed-off-by: Pantelis Antoniou <redacted> --- .../bindings/gpio/jnx,gpio-ptxpmb-ext-cpld.txt | 36 ++++++++++++++++++++++ 1 file changed, 36 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-ext-cpld.txt
diff --git a/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-ext-cpld.txt b/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-ext-cpld.txt
new file mode 100644
index 0000000..87f01b9
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/jnx,gpio-ptxpmb-ext-cpld.txt@@ -0,0 +1,36 @@ +Juniper PTXPMB extended CPLD GPIO block + +Required properties: + +- compatible: + Must be "jnx,gpio-ptxpmb-ext-cpld" + +- #gpio-cells: + Should be <2>. The first cell is the pin number (within the controller's + pin space), and the second is used for the following flags: + bit[0]: direction (0 = out, 1 = in) + bit[1]: init high + bit[2]: active low + +- gpio-controller: + Specifies that the node is a GPIO controller. + +- interrupt-controller: + Specifies that the node is an interrupt controller. + +Optional properties: + +- reg: + Address and length of the register set for the device. Usually supplied + by the parent MFD device. + + +Example: + +gpio_ext_cpld: cpld-ext-gpio { + compatible = "jnx,gpio-ptxpmb-ext-cpld"; + #gpio-cells = <2>; + #interrupt-cells = <2>; + gpio-controller; + interrupt-controller; +};
--
1.9.1