[PATCH v2 2/5] fbdev: ssd1307fb: Remove reset-active-low from the DT binding document
DORMANTno replies
From: Jyri Sarha <hidden>
Date: 2017-01-13 10:35:46
Also in:
linux-devicetree
Subsystem:
drm drivers, drm drivers and misc gpu patches, open firmware and flattened device tree bindings, the rest · Maintainers:
David Airlie, Simona Vetter, Maarten Lankhorst, Maxime Ripard, Thomas Zimmermann, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Possibly related (same subject, not in this thread)
- 2017-01-19 · Re: [PATCH v2 2/5] fbdev: ssd1307fb: Remove reset-active-low from the DT binding document · Jyri Sarha <hidden>
- 2017-01-18 · Re: [PATCH v2 2/5] fbdev: ssd1307fb: Remove reset-active-low from the DT binding document · Rob Herring <hidden>
Remove reset-active-low from the devicetree binding document. The actual implementation has never been there in the driver code and there is no reason to add it because the gpiod API supports gpio flags, including GPIO_ACTIVE_LOW, directly trough its own devicetree binding. Signed-off-by: Jyri Sarha <redacted> --- Documentation/devicetree/bindings/display/ssd1307fb.txt | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/display/ssd1307fb.txt b/Documentation/devicetree/bindings/display/ssd1307fb.txt
index eb31ed4..4aee67f 100644
--- a/Documentation/devicetree/bindings/display/ssd1307fb.txt
+++ b/Documentation/devicetree/bindings/display/ssd1307fb.txt@@ -8,14 +8,14 @@ Required properties: 0x3c or 0x3d - pwm: Should contain the pwm to use according to the OF device tree PWM specification [0]. Only required for the ssd1307. - - reset-gpios: Should contain the GPIO used to reset the OLED display + - reset-gpios: Should contain the GPIO used to reset the OLED display. See + Documentation/devicetree/bindings/gpio/gpio.txt for details. - solomon,height: Height in pixel of the screen driven by the controller - solomon,width: Width in pixel of the screen driven by the controller - solomon,page-offset: Offset of pages (band of 8 pixels) that the screen is mapped to. Optional properties: - - reset-active-low: Is the reset gpio is active on physical low? - solomon,segment-no-remap: Display needs normal (non-inverted) data column to segment mapping - solomon,com-seq: Display uses sequential COM pin configuration
--
1.9.1