Re: [PATCH] Fix loading of module radeonfb on PowerMac

On Wed, Nov 02, 2016 at 10:28:55AM +0200, Tomi Valkeinen wrote:

On 08/10/16 15:09, Mathieu Malaterre wrote:

quoted

When the linux kernel is build with (typical kernel ship with Debian
installer):

CONFIG_FB_OF=y
CONFIG_VT_HW_CONSOLE_BINDING=y
CONFIG_FB_RADEON=m

The offb driver takes precedence over module radeonfb. It is then
impossible to load the module, error reported is:

[   96.551486] radeonfb 0000:00:10.0: enabling device (0006 -> 0007)
[   96.551526] radeonfb 0000:00:10.0: BAR 0: can't reserve [mem 0x98000000-0x9fffffff pref]
[   96.551531] radeonfb (0000:00:10.0): cannot request region 0.
[   96.551545] radeonfb: probe of 0000:00:10.0 failed with error -16

This patch reproduce the behavior of the module radeon, so as to make it
possible to load radeonfb when offb is first loaded.

It should be noticed that `offb_destroy` is never called which explain the
need to skip error detection on the radeon side.

Why is that? It sounds rather bad if two drivers claim the same resources.

My understanding from reading through the console code is that you only
call destroy when the driver isn't in use anymore, and that doesn't
happen until something else takes over the console, which can't happen
until the new driver is active, which can't happen because the resources
are already claimed by the old driver.

PCs might be able to drop back to text console, but powerpc doesn't have
one of those so offb stays active until something else takes over the
console job it seems.

The radeon driver doesn't reserve resources, it just uses them.
This seems to be the case of quite a few drivers.

-- 
Len Sorensen