[RESEND PATCH 1/2] devicetree: mxsfb: add reset-active property
From: Mans Rullgard <hidden>
Date: 2016-01-12 10:22:57
Also in:
linux-devicetree, lkml
Subsystem:
drm drivers, drm drivers and misc gpu patches, open firmware and flattened device tree bindings, the rest · Maintainers:
David Airlie, Simona Vetter, Maarten Lankhorst, Maxime Ripard, Thomas Zimmermann, Rob Herring, Krzysztof Kozlowski, Conor Dooley, Linus Torvalds
Some boards connect the LCD_RESET pin to a reset input on the display panel. On these boards, this pin must be set to the proper level for the display to function. This adds an optional "reset-active" property to the "display" subnode such that devicetrees can specify the desired polarity of the LCD_RESET pin. Signed-off-by: Mans Rullgard <redacted> --- Documentation/devicetree/bindings/display/mxsfb.txt | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/Documentation/devicetree/bindings/display/mxsfb.txt b/Documentation/devicetree/bindings/display/mxsfb.txt
index 96ec5179c8a0..cb7212a6bdf2 100644
--- a/Documentation/devicetree/bindings/display/mxsfb.txt
+++ b/Documentation/devicetree/bindings/display/mxsfb.txt@@ -13,6 +13,11 @@ Required properties: - bits-per-pixel : <16> for RGB565, <32> for RGB888/666. - bus-width : number of data lines. Could be <8>, <16>, <18> or <24>. +Optional properties: +- reset-active : <0>: reset pin is active low + <1>: reset pin is active high + omitted: reset pin not used + Required sub-node: - display-timings : Refer to binding doc display-timing.txt for details.
--
2.7.0