Re: [PATCH] pwm-backlight: add support for device tree gpio control

On Thu, Sep 26, 2013 at 01:13:18PM +0300, Tomi Valkeinen wrote:

On 11/09/13 14:40, Mike Dunn wrote:

quoted

On 09/10/2013 10:21 AM, Thierry Reding wrote:

quoted

quoted

Do you have a real setup that actually needs multiple GPIOs? Usually
such a setup requires some kind of timing or other additional constraint
which can't be represented by this simple binding.

Looking at the Palm Treo code it seems like the reason why multiple
GPIOs are needed is because one is to enable the backlight, while the
other is in fact used to enable the LCD panel. 

There are actually four GPIOs involved!  (There is an embarrasingly horrible
hack in arch/arm/mach-pxa/palmtreo.c that handles the others.)  One is almost
certainly simply backlight power.  The other three are probably LCD related.

When you say "power", do you mean the gpio enables a regulator to feed
power to the backlight? If so, wouldn't that be a regulator, not gpio,
from the bl driver's point of view?

Generally speaking, this same problem appears in many places, but for
some reason especially in display. I'm a bit hesitant in adding "free
form" gpio/regulator support for drivers, as, as Thierry pointed out,
there are often timing requirements, or sometimes the gpios are
inverted, or sometimes the gpio is, in fact, a reset gpio, where you'll
assert the gpio for a short moment only.

I sent out another series a few days ago that somewhat obsoletes this
patch. What it does is basically add a single enable GPIO that can be
used to turn the backlight on and off. In a separate patch, support is
added for a power regulator. The combination of both should be able to
cover the majority of use-cases.

That series doesn't handle any timing requirements, but again, for the
majority of the setups supported by a power supply and enable GPIO the
timing doesn't matter.

I haven't seen new versions for the power sequences framework (without
DT support), I think it could help us here a bit by simplifying how we
present the sequences inside the driver. But we still need multiple
drivers or the same driver supporting multiple devices.

I'm not sure if power sequences will be very helpful here. There was an
attempt to get those merged, but the patches were NAKed in the end. I'm
not aware of any work currently being done on them.

But as I said above, the combination of an enable GPIO and power supply
should be enough to get a lot of use-cases supported.

And I also think that the model where we have just one driver for, say,
backlight may not be enough. There may be multiple hardware components,
that used together will generate the backlight. And each component
requires specific management.

I'm not sure what other components you are talking about here. Can you
elaborate?

Thierry