On Fri, Jul 05, 2013 at 03:51:42PM +0800, Alison Wang wrote:

The Display Controller Unit (DCU) module is a system master that
fetches graphics stored in internal or external memory and displays
them on a TFT LCD panel. A wide range of panel sizes is supported
and the timing of the interface signals is highly configurable.
Graphics are read directly from memory and then blended in real-time,
which allows for dynamic content creation with minimal CPU intervention.

The features:

(1) Full RGB888 output to TFT LCD panel.
(2) For the current LCD panel, WQVGA "480x272" is supported.
(3) Blending of each pixel using up to 4 source layers dependent on size of panel.
(4) Each graphic layer can be placed with one pixel resolution in either axis.
(5) Each graphic layer support RGB565 and RGB888 direct colors without alpha channel
and BGRA8888 direct colors with an alpha channel.
(6) Each graphic layer support alpha blending with 8-bit resolution.

This driver has been tested on Vybrid VF610 TOWER board.

Signed-off-by: Alison Wang <redacted>
---
 drivers/video/Kconfig      |    9 +
 drivers/video/Makefile     |    1 +
 drivers/video/fsl-dcu-fb.c | 1091 ++++++++++++++++++++++++++++++++++++++++++++
 3 files changed, 1101 insertions(+)
 create mode 100644 drivers/video/fsl-dcu-fb.c

You should have a document under Documentation/devicetree/bindings/fb/.

Shawn