On Thursday, July 25, 2013 10:05 PM, Maxime Ripard wrote:
The IM pins of the HX8357 controller are used to define the interface
used to feed pixel stream to the LCD panel.
Most of the time, these pins are directly routed to either the ground or
the VCC to set their values.
Remove the need to assign GPIOs to these pins when we are in such a case.
Signed-off-by: Maxime Ripard <redacted>
---
drivers/video/backlight/hx8357.c | 53 +++++++++++++++++++++++-----------------
1 file changed, 31 insertions(+), 22 deletions(-)
[.....]
+ if (of_find_property(spi->dev.of_node, "im-gpios", NULL)) {
+ lcd->use_im_pins = 1;
+
+ for (i = 0; i < HX8357_NUM_IM_PINS; i++) {
+ lcd->im_pins[i] = of_get_named_gpio(spi->dev.of_node,
+ "im-gpios", i);
+ if (lcd->im_pins[i] = -EPROBE_DEFER) {
+ dev_info(&spi->dev, "GPIO requested is not here yet, deferring the
probe\n");
+ return -EPROBE_DEFER;
+ }
+ if (!gpio_is_valid(lcd->im_pins[i])) {
+ dev_err(&spi->dev, "Missing dt property: im-gpios\n");
+ return -EINVAL;
+ }
+
+ ret = devm_gpio_request_one(&spi->dev, lcd->im_pins[i],
+ GPIOF_OUT_INIT_LOW,
+ "im_pins");
+ if (ret) {
+ dev_err(&spi->dev, "failed to request gpio %d: %d\n",
+ lcd->im_pins[i], ret);
+ return -EINVAL;
+ }
}
-
- ret = devm_gpio_request_one(&spi->dev, lcd->im_pins[i],
- GPIOF_OUT_INIT_LOW, "im_pins");
- if (ret) {
- dev_err(&spi->dev, "failed to request gpio %d: %d\n",
- lcd->im_pins[i], ret);
- return -EINVAL;
- }
- }
+ } else
+ lcd->use_im_pins = 0;
According to the 'Documentation/CodingStyle', braces are necessary as below.
} else {
lcd->use_im_pins = 0;
}
Others look good.
Acked-by: Jingoo Han <redacted>
Best regards,
Jingoo Han