[PATCH 2/2] ARM: dts: cfa10036: Change the OLED display to SSD1306
flat view
STALE4931d
From: Maxime Ripard <hidden>
Date: 2013-04-12 08:00:13
Also in:
linux-arm-kernel, lkml
Subsystem:
the rest · Maintainer:
Linus Torvalds
Revision resend of 2 in this series.
Revisions (2)
- v1 [diff vs current]
- resend current
The SSD1307 was used in an early prototype that will never get distributed. The final board now has a SSD1306 instead, that has its own power generation unit and thus doesn't need any PWM. The panel attached to it also changed. Signed-off-by: Maxime Ripard <redacted> --- arch/arm/boot/dts/imx28-cfa10036.dts | 14 +++++--------- arch/arm/boot/dts/imx28-cfa10049.dts | 4 ++-- 2 files changed, 7 insertions(+), 11 deletions(-)
diff --git a/arch/arm/boot/dts/imx28-cfa10036.dts b/arch/arm/boot/dts/imx28-cfa10036.dts
index 1594694..40488f5a8 100644
--- a/arch/arm/boot/dts/imx28-cfa10036.dts
+++ b/arch/arm/boot/dts/imx28-cfa10036.dts@@ -58,12 +58,6 @@ }; apbx@80040000 { - pwm: pwm@80064000 { - pinctrl-names = "default"; - pinctrl-0 = <&pwm4_pins_a>; - status = "okay"; - }; - duart: serial@80074000 { pinctrl-names = "default"; pinctrl-0 = <&duart_pins_b>;
@@ -75,11 +69,13 @@ pinctrl-0 = <&i2c0_pins_b>; status = "okay"; - ssd1307: oled@3c { - compatible = "solomon,ssd1307fb-i2c"; + ssd1306: oled@3c { + compatible = "solomon,ssd1306fb-i2c"; reg = <0x3c>; - pwms = <&pwm 4 3000>; reset-gpios = <&gpio2 7 0>; + solomon,height = <32>; + solomon,width = <128>; + solomon,page-offset = <0>; }; }; };
diff --git a/arch/arm/boot/dts/imx28-cfa10049.dts b/arch/arm/boot/dts/imx28-cfa10049.dts
index a0d3e9f..ded7784 100644
--- a/arch/arm/boot/dts/imx28-cfa10049.dts
+++ b/arch/arm/boot/dts/imx28-cfa10049.dts@@ -132,8 +132,8 @@ apbx@80040000 { pwm: pwm@80064000 { - pinctrl-names = "default", "default"; - pinctrl-1 = <&pwm3_pins_b>; + pinctrl-names = "default"; + pinctrl-0 = <&pwm3_pins_b>; status = "okay"; };
--
1.7.10.4