Re: [PATCH 1/4] video: Add support for the Solomon SSD1307 OLED Controller

On Wed, Aug 01, 2012 at 12:28:27PM +0200, Maxime Ripard wrote:

Thanks for the tip.
However, I'm not sure this device will be mxs specific, since this
controller is used on some other devices as well (I know for example
that some uses it with the Arduino, even though it's not related to
Linux), so relying on mxs-specific capabilities here might not be that
great.

Ok, agreed.  In that case, putting "1" in last cell of oled-reset-gpio
does not make any point then.

+Examples:
+ssd1307: oled@3c {
+        compatible = "solomon,ssd1307fb-i2c";
+        reg = <0x3c>;
+        pwms = <&pwm 4 3000>;
+        oled-reset-gpio = <&gpio2 7 1>;
+        oled-reset-active-low;
+};

-- 
Regards,
Shawn