Re: [PATCH] 0/3 Add I2C/DDC support to radeonfb (resend)
From: Sven Luther <hidden>
Date: 2003-08-25 09:40:41
On Sat, Aug 23, 2003 at 01:43:53AM +0200, Michel Dänzer wrote:
On Fri, 2003-08-22 at 19:09, Kronos wrote:quoted
i2c bus is registered in radeonfb_pci_register and unregistered in radeonfb_pci_unregister. I'm a bit concerned about XFree that uses the same bus...If there was an interface to userspace, the X driver could use that? BTW, regarding the EDID discussion, I'm not sure that a list of modes will cut it - e.g., the EDID of the panel in this TiBook only contains the native mode, but the chip can scale up pretty much any lower resolution.
Which is a good thing, compared to my sony SDM-X52, which in digital mode only supports the native resolution, but the EDID erroneously reports the mode supported by the digital connection in both case. The EDID should report only the supported (native) mode, and the chip, knowing what it can scale or not, should handle the other cases, no ? Friendly, Sven Luther ------------------------------------------------------- This SF.net email is sponsored by: VM Ware With VMware you can run multiple operating systems on a single machine. WITHOUT REBOOTING! Mix Linux / Windows / Novell virtual machines at the same time. Free trial click here:http://www.vmware.com/wl/offer/358/0