[PATCH 33/53] docs: riscv: vm-layout.rst: avoid using UTF-8 chars
From: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
Date: 2021-05-10 10:34:24
Also in:
linux-riscv, lkml
Subsystem:
documentation, the rest · Maintainers:
Jonathan Corbet, Linus Torvalds
While UTF-8 characters can be used at the Linux documentation,
the best is to use them only when ASCII doesn't offer a good replacement.
So, replace the occurences of the following UTF-8 characters:
- U+2013 ('–'): EN DASH
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
---
Documentation/riscv/vm-layout.rst | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/Documentation/riscv/vm-layout.rst b/Documentation/riscv/vm-layout.rst
index 329d32098af4..545f8ab51f1a 100644
--- a/Documentation/riscv/vm-layout.rst
+++ b/Documentation/riscv/vm-layout.rst@@ -22,7 +22,7 @@ RISC-V Linux Kernel 64bit ========================= The RISC-V privileged architecture document states that the 64bit addresses -"must have bits 63–48 all equal to bit 47, or else a page-fault exception will +"must have bits 63-48 all equal to bit 47, or else a page-fault exception will occur.": that splits the virtual address space into 2 halves separated by a very big hole, the lower half is where the userspace resides, the upper half is where the RISC-V Linux Kernel resides.
--
2.30.2