[PATCH 09/53] docs: admin-guide: perf: imx-ddr.rst: avoid using UTF-8 chars
From: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
Date: 2021-05-10 10:31:59
Also in:
linux-arm-kernel, lkml
Subsystem:
documentation, freescale imx ddr pmu driver, the rest · Maintainers:
Jonathan Corbet, Frank Li, Xu Yang, Linus Torvalds
While UTF-8 characters can be used at the Linux documentation,
the best is to use them only when ASCII doesn't offer a good replacement.
So, replace the occurences of the following UTF-8 characters:
- U+201c ('“'): LEFT DOUBLE QUOTATION MARK
- U+201d ('”'): RIGHT DOUBLE QUOTATION MARK
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
---
Documentation/admin-guide/perf/imx-ddr.rst | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/Documentation/admin-guide/perf/imx-ddr.rst b/Documentation/admin-guide/perf/imx-ddr.rst
index 90926d0fb8ec..269d0b564903 100644
--- a/Documentation/admin-guide/perf/imx-ddr.rst
+++ b/Documentation/admin-guide/perf/imx-ddr.rst@@ -9,7 +9,7 @@ control register which causes a large number of PERF signals to be generated. Selection of the value for each counter is done via the config registers. There is one register for each counter. Counter 0 is special in that it always counts -“time” and when expired causes a lock on itself and the other counters and an +"time" and when expired causes a lock on itself and the other counters and an interrupt is raised. If any other counter overflows, it continues counting, and no interrupt is raised.
--
2.30.2