Re: [PATCH v4 0/6] Add PCIe support for Qualcomm Nord platform

On Mon, Sep 21, 2026 at 11:07:08AM +0530, Krishna Chaitanya Chundru wrote:

This series adds PCIe support for the Qualcomm Nord (SA8797P) platform.

Nord has a single Gen5-capable QMP PCIe PHY block split into four
independently-clocked and independently-resettable ports (A/B/C/D).
Firmware selects the active lane topology at boot via a TCSR
configuration register, and the same PHY block can appear as a single
x16 port, x8+x8, x8+x4+x4, or x8+x4+x2+x2 depending on that mode. This
is similar in spirit to the Glymur multi-PHY support already posted,
except Nord's PHY registers are programmed by Linux rather than by
firmware, so this series adds the PLL, TXRXZ, PCS and PCS-lane init
tables along with the power-up/power-down/soft-reset sequencing needed
to bring each port up.

The series also documents and wires up the qcom,nord-pcie compatible
(reusing the existing SA8775P PCIe controller binding), and adds a
CORE_CLK_CGC_DIS/AUX_PWR_DET workaround required to avoid a timing
convergence issue in the PCIe power domain.

Signed-off-by: Krishna Chaitanya Chundru <redacted>

Tested on Glymur CRD and Glymur QCB, devices can be enumerated.

Tested-by: Qiang Yu <redacted>

- Qiang Yu