On 9/5/26 5:29 PM, Krishna Kurapati wrote:
eUSB2 targets handle wakeup interrupts differently depending on device
speed when operating in host mode.
According to the eUSB2 specification, remote wakeup signaling in host
mode is detected via different data-line assertions based on the
connected device speed.
[...]
quoted hunk ↗ jump to hunk
@@ -628,6 +649,7 @@ static int dwc3_qcom_probe(struct platform_device *pdev)
int ret;
bool ignore_pipe_clk;
bool wakeup_source;
+ struct phy *phy;
qcom = devm_kzalloc(&pdev->dev, sizeof(*qcom), GFP_KERNEL);
if (!qcom)
@@ -698,6 +720,17 @@ static int dwc3_qcom_probe(struct platform_device *pdev)
if (ret)
goto clk_disable;
+ phy = devm_of_phy_get_by_index(dev, dev->of_node, 0);
+ if (IS_ERR(phy)) {
+ if (PTR_ERR(phy) != -ENODEV) {
GPT reports:
When CONFIG_GENERIC_PHY is disabled, the stub in include/linux/phy/phy.h:489-493
returns ERR_PTR(-ENOSYS). The patch only treats -ENODEV as “no PHY”:
But it's not like one can really use this driver without a PHY..
We can add a follow-up to depend on that for the qcom driver
otherwise
Acked-by: Konrad Dybcio <redacted>
Konrad