[PATCH v4 0/3] phy: nuvoton: extend MA35D1 USB2 PHY driver for dual-port OTG support

The MA35D1 SoC has two USB PHY ports managed by a shared hardware block:

  - PHY0 (USB0): OTG port shared between the DWC2 gadget controller and
    the EHCI0/OHCI0 host controllers.  A hardware mux automatically routes
    USB0 signals to the correct controller based on the USB ID pin state.

  - PHY1 (USB1): dedicated host-only port for EHCI1/OHCI1.

This series extends the existing phy-ma35d1-usb2.c driver and its binding
to cover both ports and add OTG role-switch support, while keeping full
backward compatibility with existing device trees.

Changes since v3:

  - dt-bindings: add nuvoton,rcalcode = <7 7> example to illustrate the
    optional resistor calibration property; revert redundant clock example
    change (back to USBD_GATE as in the original binding).

  - driver: handle -ENODEV from usb_role_switch_register() gracefully so
    that probe succeeds when CONFIG_USB_ROLE_SWITCH is not enabled.

Joey Lu (3):
  dt-bindings: phy: nuvoton,ma35d1-usb2-phy: extend for dual-port and
    OTG
  arm64: dts: nuvoton: ma35d1: add USB controllers and dual-port PHY
    node
  phy: nuvoton: phy-ma35d1-usb2: extend to dual-port with OTG support

 .../bindings/phy/nuvoton,ma35d1-usb2-phy.yaml |  44 ++-
 .../boot/dts/nuvoton/ma35d1-iot-512m.dts      |  36 +++
 .../boot/dts/nuvoton/ma35d1-som-256m.dts      |  36 +++
 arch/arm64/boot/dts/nuvoton/ma35d1.dtsi       |  65 ++++
 drivers/phy/nuvoton/phy-ma35d1-usb2.c         | 284 +++++++++++++-----
 5 files changed, 389 insertions(+), 76 deletions(-)

base-commit: dc59e4fea9d83f03bad6bddf3fa2e52491777482
-- 
2.43.0