On 1/29/26 5:32 PM, Manivannan Sadhasivam wrote:

On Thu, Jan 29, 2026 at 01:07:08PM +0100, Konrad Dybcio wrote:

quoted

On 1/29/26 1:05 PM, Qiang Yu wrote:

quoted

On Wed, Jan 28, 2026 at 07:21:04PM -0600, Bjorn Andersson wrote:

quoted

On Thu, Jan 22, 2026 at 08:53:57PM +0530, Pankaj Patil wrote:

quoted

Introduce dt-bindings and initial device tree support for Glymur,
Qualcomm's next-generation compute SoC and it's associated
Compute Reference Device (CRD) platform.

https://www.qualcomm.com/products/mobile/snapdragon/laptops-and-tablets/snapdragon-x2-elite
https://www.qualcomm.com/news/releases/2025/09/new-snapdragon-x2-elite-extreme-and-snapdragon-x2-elite-are-the-

The base support enables booting to shell with rootfs on NVMe,
demonstrating functionality for PCIe and NVMe subsystems.
DCVS is also enabled, allowing dynamic frequency scaling for the CPUs.
TSENS (Thermal Sensors) enabled for monitoring SoC temperature and
thermal management. The platform is capable of booting kernel at EL2
with kvm-unit tests performed on it for sanity.

Added dtsi files for the PMIC's enabled PMH0101, PMK8850, PMCX0102,
SMB2370, PMH0104, PMH0110 along with temp-alarm and GPIO nodeS.

For CPU compatible naming, there is one discussion which is not specific
to Glymur, Kaanapali and Glymur use the same Oryon cores.
https://lore.kernel.org/all/20251119-oryon-binding-v1-1-f79a101b0391@oss.qualcomm.com/ (local)
We've kept the "qcom,oryon" compatible

Features enabled in this patchset:
1. NVMe storage support
2. PCIe controller and PCIe PHY
3. RPMH Regulators
4. Clocks and reset controllers - GCC, TCSRCC, DISPCC, RPMHCC
5. Interrupt controller
6. TLMM (Top-Level Mode Multiplexer)
7. QUP Block
8. Reserved memory regions
9. PMIC support with regulators
10. CPU Power Domains
11. TSENS (Thermal Sensors)
12. DCVS: CPU DCVS with scmi perf protocol

Dependencies:

dt-bindings:
1. https://lore.kernel.org/all/20260121-glymur-pmic-mfd-v1-1-2aab4f21e79c@oss.qualcomm.com/ (local)
2. https://lore.kernel.org/all/20251215-knp-pmic-leds-v3-2-5e583f68b0e5@oss.qualcomm.com/ (local)
3. https://lore.kernel.org/all/20260121110828.2267061-1-pankaj.patil@oss.qualcomm.com/ (local)
4. https://lore.kernel.org/all/20260111155234.5829-1-pankaj.patil@oss.qualcomm.com/ (local)

Linux-next based tree with Glymur patches is available at:
https://git.codelinaro.org/clo/linux-kernel/kernel-qcom/-/tree/b4/v6_glymur_introduction

FWIW, I applied these patches onto next-20260128 to see if things has
improved since Rob's report and I get:

$ make qcom/glymur-crd.dtb CHECK_DTBS=1
  DTC [C] arch/arm64/boot/dts/qcom/glymur-crd.dtb
qcom/glymur-crd.dtb: dma-controller@800000 (qcom,glymur-gpi-dma): interrupts: [[0, 588, 4], [0, 589, 4], [0, 590, 4], [0, 591, 4], [0, 592, 4], [0, 593, 4], [0, 594, 4], [0, 595, 4], [0, 596, 4], [0, 597, 4], [0, 598, 4], [0, 599, 4], [2, 129, 4], [2, 130, 4], [2, 131, 4], [2, 132, 4]] is too long
        from schema $id: http://devicetree.org/schemas/dma/qcom,gpi.yaml#
qcom/glymur-crd.dtb: dma-controller@a00000 (qcom,glymur-gpi-dma): interrupts: [[0, 279, 4], [0, 280, 4], [0, 281, 4], [0, 282, 4], [0, 283, 4], [0, 284, 4], [0, 293, 4], [0, 294, 4], [0, 295, 4], [0, 296, 4], [0, 297, 4], [0, 298, 4], [2, 124, 4], [2, 125, 4], [2, 126, 4], [2, 127, 4]] is too long
        from schema $id: http://devicetree.org/schemas/dma/qcom,gpi.yaml#
qcom/glymur-crd.dtb: dma-controller@b00000 (qcom,glymur-gpi-dma): interrupts: [[2, 76, 4], [2, 77, 4], [2, 78, 4], [2, 79, 4], [2, 80, 4], [2, 81, 4], [2, 82, 4], [2, 83, 4], [2, 84, 4], [2, 85, 4], [2, 86, 4], [2, 87, 4], [2, 88, 4], [2, 89, 4], [2, 90, 4], [2, 91, 4]] is too long
        from schema $id: http://devicetree.org/schemas/dma/qcom,gpi.yaml#
qcom/glymur-crd.dtb: pmic@1 (qcom,pmh0101): led-controller@ee00:compatible:0: 'qcom,pmh0101-flash-led' is not one of ['qcom,pm6150l-flash-led', 'qcom,pm660l-flash-led', 'qcom,pm7550-flash-led', 'qcom,pm8150c-flash-led', 'qcom,pm8150l-flash-led', 'qcom,pm8350c-flash-led', 'qcom,pm8550-flash-led', 'qcom,pmi8998-flash-led']
        from schema $id: http://devicetree.org/schemas/mfd/qcom,spmi-pmic.yaml#
qcom/glymur-crd.dtb: pmic@1 (qcom,pmh0101): pwm:compatible: 'oneOf' conditional failed, one must be fixed:
        ['qcom,pmh0101-pwm', 'qcom,pm8350c-pwm'] is too long
        'qcom,pmh0101-pwm' is not one of ['qcom,pm660l-lpg', 'qcom,pm8150b-lpg', 'qcom,pm8150l-lpg', 'qcom,pm8350c-pwm', 'qcom,pm8916-pwm', 'qcom,pm8941-lpg', 'qcom,pm8994-lpg', 'qcom,pmc8180c-lpg', 'qcom,pmi632-lpg', 'qcom,pmi8950-pwm', 'qcom,pmi8994-lpg', 'qcom,pmi8998-lpg', 'qcom,pmk8550-pwm']
        'qcom,pmh0101-pwm' is not one of ['qcom,pm6150l-lpg']
        'qcom,pmh0101-pwm' is not one of ['qcom,pm8550-pwm']
        'qcom,pmh0101-pwm' is not one of ['qcom,pm8937-pwm']
        'qcom,pm8150l-lpg' was expected
        'qcom,pm8916-pwm' was expected
        from schema $id: http://devicetree.org/schemas/mfd/qcom,spmi-pmic.yaml#
qcom/glymur-crd.dtb: led-controller@ee00 (qcom,pmh0101-flash-led): compatible:0: 'qcom,pmh0101-flash-led' is not one of ['qcom,pm6150l-flash-led', 'qcom,pm660l-flash-led', 'qcom,pm7550-flash-led', 'qcom,pm8150c-flash-led', 'qcom,pm8150l-flash-led', 'qcom,pm8350c-flash-led', 'qcom,pm8550-flash-led', 'qcom,pmi8998-flash-led']
        from schema $id: http://devicetree.org/schemas/leds/qcom,spmi-flash-led.yaml#
qcom/glymur-crd.dtb: /soc@0/arbiter@c400000/spmi@c426000/pmic@1/led-controller@ee00: failed to match any schema with compatible: ['qcom,pmh0101-flash-led', 'qcom,spmi-flash-led']
qcom/glymur-crd.dtb: pwm (qcom,pmh0101-pwm): compatible: 'oneOf' conditional failed, one must be fixed:
        ['qcom,pmh0101-pwm', 'qcom,pm8350c-pwm'] is too long
        'qcom,pmh0101-pwm' is not one of ['qcom,pm660l-lpg', 'qcom,pm8150b-lpg', 'qcom,pm8150l-lpg', 'qcom,pm8350c-pwm', 'qcom,pm8916-pwm', 'qcom,pm8941-lpg', 'qcom,pm8994-lpg', 'qcom,pmc8180c-lpg', 'qcom,pmi632-lpg', 'qcom,pmi8950-pwm', 'qcom,pmi8994-lpg', 'qcom,pmi8998-lpg', 'qcom,pmk8550-pwm']
        'qcom,pmh0101-pwm' is not one of ['qcom,pm6150l-lpg']
        'qcom,pmh0101-pwm' is not one of ['qcom,pm8550-pwm']
        'qcom,pmh0101-pwm' is not one of ['qcom,pm8937-pwm']
        'qcom,pm8150l-lpg' was expected
        'qcom,pm8916-pwm' was expected
        from schema $id: http://devicetree.org/schemas/leds/leds-qcom-lpg.yaml#
qcom/glymur-crd.dtb: /soc@0/arbiter@c400000/spmi@c426000/pmic@1/pwm: failed to match any schema with compatible: ['qcom,pmh0101-pwm', 'qcom,pm8350c-pwm']

So, we're still missing a few dependencies.


Booting the system I get a ton of errors from PCIe in the kernel log:

debugfs: 'opp:5000000' already exists in 'soc@0-1c00000.pci'

# dmesg | grep -E 'debugfs: .+ already exists' |wc -l
508

The system does eventually boot, and I was happy to see that we do end
up finding the PCIe devices after all.

I enabled dynamic debug logs and observed that each PCIe platform device
probe was deferred approximately 10 times. The probe deferrals resulted in
additional OPP debugfs warnings being printed.

The PCIe platform device probe was deferred because the PHY driver was not
ready - either because the PHY driver was not yet loaded, or because the
PHY driver's own probe was also deferred due to its dependency (e.g.,
1fd5000.clock-controller) not being ready. This is normal behavior,
correct? I also observed that other driver probes were deferred.

But I'm not sure why there are more than 300 times probe deferrals on
your setup.

I think Bjorn is trying to say that the driver is wrong, because it
effectively seems to call devm_pm_opp_of_add_table repeatedly

We did try to avoid that by guarding it with dev_pm_opp_get_opp_count(). But
that doesn't seem to be helping. The error might be due to duplicate non-shared
opp entries, but I'm yet to confirm.

What if you just move the devm_pm_opp_of_add_table() to after the calls
that can return -EPROBE_DEFER?

Konrad