Re: [PATCH v5 2/2] iio: pressure: add Honeywell ABP2 driver

On Sat, 3 Jan 2026 15:21:45 +0200
Andy Shevchenko [off-list ref] wrote:

On Sat, Jan 03, 2026 at 06:35:17AM +0200, Petre Rodan wrote:

quoted

Adds driver for digital Honeywell ABP2 series of board mount
pressure and temperature sensors.

This driver covers 113 different pressure ranges and units on
both i2c and SPI buses.

The communication protocol involves sending two simple commands
to the sensor and there is no register access or a memory map.
For this reason the regmap API was not used.

The i2c address is hardcoded and depends on the part number.

Optional end of conversion interrupt control is present on the
i2c variants of the chips.
The EOC can also be defined for the SPI variants if a non-ABP2
but compatible chip is to be driven.

Tested on two sensors (ABP2MRRT001PDSA3 and ABP2DANT001BA2A3).  

quoted

ocuments/sps-siot-abp2-series-datasheet-32350268-en.pdf  

Broken link now.

quoted

Datasheet: https://prod-edam.honeywell.com/content/dam/honeywell-edam/sps/siot/en-us/products/sensors/pressure-sensors/board-mount-pressure-sensors/basic-abp2-series/d  

Should be in this line, but do *not* resend just for this, I hope if everything
else is okay, Jonathan will fix the above issue.

quoted

Reviewed-by: Andy Shevchenko <redacted>
Signed-off-by: Petre Rodan <petre.rodan@subdimension.ro>  

As I replied to v4, this is now a long way back in the tree so
I'm not going to rebase.  Please send a patch on top of the
testing tree of iio.git making the changes.

Thanks,

Jonathan