Il 01/08/25 13:18, Julien Massot ha scritto:

The properties `mediatek,pull-up-adv` and `mediatek,pull-down-adv`
were using incorrect values like `<10>` and `<01>`. These values
are parsed as decimal (10 and 1 respectively), not binary.

However, the driver interprets these as bitfields:
   - BIT(0): R0
   - BIT(1): R1

So valid values are:
   - 0 => no pull
   - 1 => enable R0
   - 2 => enable R1
   - 3 => enable R0 + R1

Using `<10>` is invalid as it exceeds the accepted range.
It was likely intended as binary `0b10` (i.e., `2`),
to enable R1 only.

This patch replaces incorrect values with the correct ones
and removes the leading zero from `<01>` to avoid confusion
with bitfield notation.

Signed-off-by: Julien Massot <julien.massot@collabora.com>

Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>