From: Chen-Yu Tsai <redacted>

Hi everyone,

This series adds support for the OrangePi 4A board. This is a Raspberry
Pi model B form factor development board based on the Allwinner T527
SoC.

The board has the following features:
- Allwinner T527 SoC
- AXP717B + AXP323 PMICs
- Up to 4GB LPDDR4 DRAM
- micro SD slot
- optional eMMC module
- M.2 slot for PCIe 2.0 x1
- 16 MB SPI-NOR flash
- 4x USB 2.0 type-A ports (one can be used in gadget mode)
- 1x Gigabit ethernet w/ Motorcomm PHY (through yet to be supported GMAC200)
- 3.5mm audio jack via internal audio codec
- HDMI 2.0 output
- eDP, MIPI CSI (2-lane and 4-lane) and MIPI DSI (4-lane) connectors
- USB type-C port purely for power
- AP6256 (Broadcom BCM4345) WiFi 5.0 + BT 5.0
- unsoldered headers for ADC and an additional USB 2.0 host port
- 40-pin GPIO header

Patch 1 adds a new entry to the list of board compatibles.

Patch 2 and 3 are minor cleanups.

Patch 4 adds pins for UART1, which is used for BT on the board.

Patch 5 adds a dts file for the new board.


Please take a look. I will take all the patches through the sunxi tree.


Thanks
ChenYu


Chen-Yu Tsai (5):
  dt-bindings: arm: sunxi: Add Xunlong OrangePi 4A board
  arm64: dts: allwinner: a523: Move mmc nodes to correct position
  arm64: dts: allwinner: a523: Move rgmii0 pins to correct location
  arm64: dts: allwinner: a523: Add UART1 pins
  arm64: dts: allwinner: t527: Add OrangePi 4A board

 .../devicetree/bindings/arm/sunxi.yaml        |   5 +
 arch/arm64/boot/dts/allwinner/Makefile        |   1 +
 .../arm64/boot/dts/allwinner/sun55i-a523.dtsi | 160 ++++----
 .../dts/allwinner/sun55i-t527-orangepi-4a.dts | 378 ++++++++++++++++++
 4 files changed, 471 insertions(+), 73 deletions(-)
 create mode 100644 arch/arm64/boot/dts/allwinner/sun55i-t527-orangepi-4a.dts

-- 
2.39.5