Hi Herve,
Am Freitag, 7. Februar 2025, 19:08:16 CET schrieb Herve Codina:
Hi Alexander,
On Thu, 06 Feb 2025 16:39:09 +0100
Alexander Stein [off-list ref] wrote:
quoted
Hi Herve,
Am Donnerstag, 6. Februar 2025, 16:20:48 CET schrieb Herve Codina:
quoted
Hi Alexander,
On Thu, 06 Feb 2025 15:38:42 +0100
Alexander Stein [off-list ref] wrote:
...
quoted
With interrupt configured I got the following stack trace upon
reboot/poweroff:
[ 91.317264] sn65dsi83 2-002d: reset the pipe
[ 91.344093] Unable to handle ke
** replaying previous printk message **
[ 91.344093] Unable to handle kernel NULL pointer dereference at virtual address 0000000000000000
...
Ouch :(
One question to help me investigating:
Do you have the issue at init/probe or when you start to display graphics?
This is during shutdown/poweroff. I assume that regmap_reg() in
sn65dsi83_handle_errors() fails and because of that reset_work is scheduled.
Found the issue.
Can you give me following information so that I can validate what I
understood:
- Is your interrupt line connected directly to the SoC?
No, unfortunately not. It's connected to a GPIO expander, which in turn
delivers an IRQ to the SoC. In between the bridge and the expander is a
buffer for voltage switch (1V8 -> 3V3).
- Is there any pullup/pulldown on your interrupt line?
As far a I can tell, there is no pullup/pulldown on the IRQ line to
the buffer.
- In your devicetree what is the configuration used for this interrupt in
terms of level or edge.
As this line is connected to an expander (pca9555) only edge triggered
interrupts are supported.
Anyway, I will send a fix in the next iteration.
Thanks for digging into this.
Best regards,
Alexander
--
TQ-Systems GmbH | Mühlstraße 2, Gut Delling | 82229 Seefeld, Germany
Amtsgericht München, HRB 105018
Geschäftsführer: Detlef Schneider, Rüdiger Stahl, Stefan Schneider
http://www.tq-group.com/