On Tue, Dec 31, 2024 at 06:10:15AM +0100, Andrew Lunn wrote:

quoted

quoted

+&ethernet0 {
+	phy-mode = "2500base-x";
+};
+
+&ethernet1 {
+	phy-mode = "2500base-x";
+};
+
+&mdio {
+	compatible = "snps,dwmac-mdio";
+	#address-cells = <1>;
+	#size-cells = <0>;
+
+	sgmii_phy0: phy@8 {
+		compatible = "ethernet-phy-id31c3.1c33";
+		reg = <0x8>;
+		device_type = "ethernet-phy";
+		interrupts-extended = <&tlmm 7 IRQ_TYPE_EDGE_FALLING>;
+		reset-gpios = <&pmm8654au_2_gpios 8 GPIO_ACTIVE_LOW>;
+		reset-assert-us = <11000>;
+		reset-deassert-us = <70000>;
+	};
+
+	sgmii_phy1: phy@0 {

SGMII is 10/100/1000. You have a phy-mode of 2500base-x, which is only
2500. So calling this sgmii_phy is wrong. Just call it phy1: phy@0.

Thanks Konrad/Andrew will fix this in next patch.

Regards,
Wasim