[PATCH v2 0/4] USB-C TCPM Orientation Support

Hi,

this adds the support to controll the optional connector-orientation
available on some TCPC from the TCPM.

I used an custom board with OnSemi FUSB307B TCPC which is spec [1]
compatible but albeit the spec [1] says that this pin is controlled by
the TCPC if 'TCPC_CONTROL.DebugAccessoryControl = 0' it isn't at least
for this device.

I'm unsure if the usb tcpci spec has an copy'n'paste failure since
'TCPC_CONTROL.DebugAccessoryControl' shouldn't control the state of the
'connector orientation' pin or if the OnSemi FUSB307B has an HW bug.
Since on my device the 'TCPC_CONTROL.DebugAccessoryControl' is set to
0 but the register wasn't updated automatically.

Regards,
  Marco

[1] https://www.usb.org/sites/default/files/documents/usb-port_controller_specification_rev2.0_v1.0_0.pdf


Marco Felsch (4):
  dt-bindings: usb: typec-tcpci: add tcpci fallback binding
  usb: typec: tcpci: add generic tcpci fallback compatible
  usb: typec: tcpm: add support to set tcpc connector orientatition
  usb: typec: tcpci: add support to set connector orientation

 .../devicetree/bindings/usb/nxp,ptn5110.yaml  |  4 +-
 drivers/usb/typec/tcpm/tcpci.c                | 45 +++++++++++++++++++
 drivers/usb/typec/tcpm/tcpm.c                 |  6 +++
 include/linux/usb/tcpci.h                     |  8 ++++
 include/linux/usb/tcpm.h                      |  2 +
 5 files changed, 64 insertions(+), 1 deletion(-)

-- 
2.39.2