Re: [PATCH 2/4] dt-bindings: pinctrl: Document nuvoton ma35d1 pin control

On Mon, Oct 16, 2023 at 9:52 PM Krzysztof Kozlowski
[off-list ref] wrote:

quoted

I noticed that 'xlnx,zynq-pinctrl.yaml' and 'xlnx,zynq-pinctrl.yaml' use
'power source' to specify the output voltage.  Should I follow their
approach or define a vendor-specific one?

Maybe Rob or Linus have here some recommendation, but I would suggest to
go either with rtd1319d-pinctrl.yaml approach or add a generic property
to pincfg-node expressed in real units like "io-microvolt".

Rob, Linus, any ideas for generic property replacing register-specific
power-source?

The existing power-source is generally used to select between (usually
two) different chip-internal power rails, such as 1.8V and 3.3V.
The format is a driver-specific enumerator.

We *could* just patch the documentation for power-source to
say that microvolts is the preferred format but legacy users may
be using a custom enumerator.

io-microvolt seems like a more long-term viable option if a wider
range of voltages are to be supported so I'm happy with that if the
DT folks think it's nicer. However notice that the power-source
property is already being hard-coded into things such as SCMI
and ACPI so it's not like it will ever be replaced by io-microvolt
and phased out as far as Linux is concerned. Not the next 50
years at least.

Yours,
Linus Walleij