On 8/25/2023 4:09 PM, Krzysztof Kozlowski wrote:

On 25/08/2023 11:35, Nitheesh Sekar wrote:

quoted

Add USB phy and controller nodes.

Co-developed-by: Amandeep Singh <redacted>
Signed-off-by: Amandeep Singh <redacted>
Signed-off-by: Nitheesh Sekar <redacted>
---
  arch/arm64/boot/dts/qcom/ipq5018.dtsi | 54 +++++++++++++++++++++++++++
  1 file changed, 54 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/ipq5018.dtsi b/arch/arm64/boot/dts/qcom/ipq5018.dtsi
index 9f13d2dcdfd5..ff477923a823 100644
--- a/arch/arm64/boot/dts/qcom/ipq5018.dtsi
+++ b/arch/arm64/boot/dts/qcom/ipq5018.dtsi

@@ -238,6 +238,60 @@
  				status = "disabled";
  			};
  		};
+
+		usbphy0: phy@5b000 {
+			compatible = "qcom,ipq5018-usb-hsphy";
+			reg = <0x0005b000 0x120>;
+
+			clocks = <&gcc GCC_USB0_PHY_CFG_AHB_CLK>;
+
+			resets = <&gcc GCC_QUSB2_0_PHY_BCR>;
+
+			#phy-cells = <0>;
+
+			status = "disabled";
+		};
+
+		usb: usb2@8a00000 {

Eee, where did you put these? Don't stuff things to the end of any list.
This applies to your entire code: Makefile, Kconfig, .c, .h, .dts, .dtsi
and other languages and projects as well.

Will reorder accordingly and post an update.

Regards,
Nitheesh