From: Hugo Villeneuve <hvilleneuve@dimonoff.com>

The sc16is7xx_config_rs485() function is called only for the second
port (index 1, channel B), causing initialization problems for the
first port.

For the sc16is7xx driver, port->membase and port->mapbase are not set,
and their default values are 0. And we set port->iobase to the device
index. This means that when the first device is registered using the
uart_add_one_port() function, the following values will be in the port
structure:
    port->membase = 0
    port->mapbase = 0
    port->iobase  = 0

Therefore, the function uart_configure_port() in serial_core.c will
exit early because of the following check:
	/*
	 * If there isn't a port here, don't do anything further.
	 */
	if (!port->iobase && !port->mapbase && !port->membase)
		return;

Typically, I2C and SPI drivers do not set port->membase and
port->mapbase.

The max310x driver sets port->membase to ~0 (all ones). By
implementing the same change in this driver, uart_configure_port() is
now correctly executed for all ports.

Fixes: dfeae619d781 ("serial: sc16is7xx")
Cc: <redacted> # 6.1.x
Signed-off-by: Hugo Villeneuve <hvilleneuve@dimonoff.com>
Reviewed-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
Reviewed-by: Lech Perczak <redacted>
Tested-by: Lech Perczak <redacted>
---
 drivers/tty/serial/sc16is7xx.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c
index 2e7e7c409cf2..8ae2afc76a9b 100644
--- a/drivers/tty/serial/sc16is7xx.c
+++ b/drivers/tty/serial/sc16is7xx.c

@@ -1436,6 +1436,7 @@ static int sc16is7xx_probe(struct device *dev,
 		s->p[i].port.fifosize	= SC16IS7XX_FIFO_SIZE;
 		s->p[i].port.flags	= UPF_FIXED_TYPE | UPF_LOW_LATENCY;
 		s->p[i].port.iobase	= i;
+		s->p[i].port.membase	= (void __iomem *)~0;
 		s->p[i].port.iotype	= UPIO_PORT;
 		s->p[i].port.uartclk	= freq;
 		s->p[i].port.rs485_config = sc16is7xx_config_rs485;

-- 
2.30.2