Elaborate on the function of this device node as well as some of the
properties that this node uses.

Signed-off-by: Bryan Brattlof <redacted>
---
 .../bindings/thermal/ti,j72xx-thermal.yaml    | 27 ++++++++++++++++++-
 1 file changed, 26 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/thermal/ti,j72xx-thermal.yaml b/Documentation/devicetree/bindings/thermal/ti,j72xx-thermal.yaml
index c74f124ebfc00..0b6a6fa07a532 100644
--- a/Documentation/devicetree/bindings/thermal/ti,j72xx-thermal.yaml
+++ b/Documentation/devicetree/bindings/thermal/ti,j72xx-thermal.yaml

@@ -9,6 +9,24 @@ title: Texas Instruments J72XX VTM (DTS) binding
 maintainers:
   - Keerthy <j-keerthy@ti.com>
 
+description: |
+  The TI K3 family of SoCs typically have a Voltage & Thermal
+  Management (VTM) device to control up to 8 temperature diode
+  sensors to measure silicon junction temperatures from different
+  hotspots of the chip as well as provide temperature, interrupt
+  and alerting information.
+
+  The VTM device will periodically enable these temperature sensors
+  to make a temperature measurement and store the reported data
+  allowing the sensors to stay in a reset state when not in use
+  to maximize the sensor's life.
+
+  This VTM driver will then use the following polynomial equation to

+  calculate the temperature from the value stored in the VTM device.
+
+  Temp = (-9.2627e-12) * x^4 + (6.0373e-08) * x^3 + \
+         (-1.7058e-04) * x^2 + (3.2512e-01) * x   + (-4.9003e+01)
+
 properties:
   compatible:
     enum:

@@ -19,9 +37,16 @@ properties:
     items:
       - description: VTM cfg1 register space
       - description: VTM cfg2 register space
-      - description: VTM efuse register space
+      - description: |
+          A software trimming method must be applied to some Jacinto
+          devices to function properly. This eFuse region provides
+          the information needed for these SoCs to report
+          temperatures accurately.
 
   power-domains:
+    description: |
+      Should contain the phandle to a power management (PM) domain
+      node and the device-id of this device.