[PATCH 2/4] ARM: dts: qcom: msm8226: override nodes by label

Using node paths to extend or override a device tree node is error
prone.  If there was a typo error, a new node will be created instead of
extending the existing node.  This will lead to run-time errors that
could be hard to detect.

A mistyped label on the other hand, will cause a dtc compile error
(during build time).  This also reduces the indentation making the code
easier to read.

The pre/post DTBS are the same.

Signed-off-by: Krzysztof Kozlowski <redacted>
---
 arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts | 6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts b/arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts
index d159188c8b95..290e1df631f0 100644
--- a/arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts
+++ b/arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts

@@ -18,8 +18,6 @@ chosen {
 	};
 };
 
-&soc {
-	serial@f991f000 {
-		status = "ok";
-	};
+&blsp1_uart3 {
+	status = "ok";
 };

-- 
2.34.1