On Tue, 12 Oct 2021 14:35:54 +0200 Alvin Šipraga wrote:

+	{ 0, 4, 2, "dot3StatsFCSErrors" },
+	{ 0, 6, 2, "dot3StatsSymbolErrors" },
+	{ 0, 8, 2, "dot3InPauseFrames" },
+	{ 0, 10, 2, "dot3ControlInUnknownOpcodes" },

...

You must expose counters via existing standard APIs.

You should implement these ethtool ops:

	void	(*get_eth_phy_stats)(struct net_device *dev,
				     struct ethtool_eth_phy_stats *phy_stats);
	void	(*get_eth_mac_stats)(struct net_device *dev,
				     struct ethtool_eth_mac_stats *mac_stats);
	void	(*get_eth_ctrl_stats)(struct net_device *dev,
				      struct ethtool_eth_ctrl_stats *ctrl_stats);
	void	(*get_rmon_stats)(struct net_device *dev,
				  struct ethtool_rmon_stats *rmon_stats,
				  const struct ethtool_rmon_hist_range **ranges);

+static int rtl8365mb_setup(struct dsa_switch *ds)
+{
+	struct realtek_smi *smi = ds->priv;
+	struct rtl8365mb *mb;
+	int ret;
+	int i;
+
+	mb = smi->chip_data;

drivers/net/dsa/rtl8365mb.c:1428:20: warning: variable ‘mb’ set but not used [-Wunused-but-set-variable]
 1428 |  struct rtl8365mb *mb;
      |                    ^~