Re: (subset) [PATCH] arm64: dts: qcom: msm8916-longcheer-l8150: Add missing sensor interrupts

On Mon, 16 Aug 2021 14:35:44 +0200, Stephan Gerhold wrote:

So far there were no interrupts set up for the BMC150 accelerometer
+ magnetometer combo because they were broken for some reason.
It turns out Longcheer L8150 actually has a BMC156 which is very similar
to BMC150, but only has an INT2 pin for the accelerometer part.

This requires some minor changes in the bmc150-accel driver which is now
supported by using the more correct bosch,bmc156_accel compatible.
Unfortunately it looks like even INT2 is not functional on most boards
because the interrupt line is not actually connected to the BMC156.
However, there are two pads next to the chip that can be shorted
to make it work if needed.

[...]

Applied, thanks!

[1/1] arm64: dts: qcom: msm8916-longcheer-l8150: Add missing sensor interrupts
      commit: 51c7786f5d4201422e076b9a3650e543a61d36da

Best regards,
-- 
Bjorn Andersson [off-list ref]