Re: [PATCH V3 3/3] gpio: modepin: Add driver support for modepin GPIO controller

On Wed, Sep 22, 2021 at 12:18 PM Bartosz Golaszewski
[off-list ref] wrote:

On Mon, Aug 23, 2021 at 10:14 AM Michal Simek [off-list ref] wrote:

quoted

Hi Bart,

On 8/23/21 10:02 AM, Bartosz Golaszewski wrote:

quoted

On Wed, Aug 18, 2021 at 10:11 AM Piyush Mehta [off-list ref] wrote:

quoted

This patch adds driver support for the zynqmp modepin GPIO controller.
GPIO modepin driver set and get the value and status of the PS_MODE pin,
based on device-tree pin configuration. These four mode pins are
configurable as input/output. The mode pin has a control register, which
have lower four-bits [0:3] are configurable as input/output, next four-bits
can be used for reading the data  as input[4:7], and next setting the
output pin state output[8:11].

Signed-off-by: Piyush Mehta <redacted>
Acked-by: Michal Simek <redacted>
Reviewed-by: Linus Walleij <redacted>
---

Which tree should this go through?

I would prefer to go this via gpio tree.

Thanks,
Michal

Sure, just make sure to get an Ack from Rob Herring on the DT bindings.

Bart

Nevermind - it's already there.

Bart