Re: [PATCHv3 1/6] ARM: dts: meson8b: odroidc1: Add usb phy power node
From: Neil Armstrong <hidden>
Date: 2021-08-31 14:50:11
Also in:
linux-amlogic, linux-arm-kernel, linux-phy, lkml
Hi, On 30/08/2021 21:37, Martin Blumenstingl wrote:
Hi Neil, On Mon, Aug 30, 2021 at 9:45 AM Neil Armstrong [off-list ref] wrote:quoted
Hi, On 17/08/2021 06:15, Anand Moon wrote:quoted
Add missing usb phy power node for usb node fix below warning. P5V0 regulator supply input voltage range to USB host controller. As described in the C1+ schematics, GPIO GPIOAO_5 is used to enable input power to USB ports, set it to Active Low. [ 1.260772] dwc2 c90c0000.usb: Looking up vbus-supply from device tree [ 1.260784] dwc2 c90c0000.usb: Looking up vbus-supply property in mode /soc/usb@c90c0000 failedFirst of all, DT is not here to fix boot message.Anand mentioned elsewhere that this is a debug/info messagequoted
Finally, I looked at the Odroid-C1 schematics and the GPIOAO.BIT5 is an input to the S805, and the PWREN signal is controlled by the USB Hub so this regulator should not be added at all.I think there's a misunderstanding because there's two PWREN signals with different meanings. The PWREN signal for the USB host ports is hard-wired and not connected to the SoC at all. The PWREN signal for the Micro-USB port (which Anand is adding here) is controlled by GPIOAO_5. odroid-c1+_rev0.4_20150615.pdf [0] shows it as an input to "USB_OTG" on page 1. "USB_OTG" consists of a power switch and the connector itself as shown on page 28. Personally I think that the change from Anand itself is good. If you feel otherwise then please speak up.
Ok thanks for the clarification, then the change is ok, but not the commit message.
quoted
Add missing usb phy power node for usb node fix below warning.
is not a good reason for a DT change. A proper reason should be added. And the commit message doesn't specify the change is for the Micro-USB port, this should be clarified. Neil
As I pointed out three smaller changes I am hoping that Anand will re-send the updated patch anyways. At that point he can also add the changes from your feedback. Best regards, Martin [0] https://dn.odroid.com/S805/Schematics/odroid-c1+_rev0.4_20150615.pdf